#2493856 - 03/31/08 08:13 PM
DYNO results with VIDEO
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
Well its finally that time, i set an apointment to dyno tune my CA legal 2000 civic si with 40k miles (on April 3), i want to see if anyone gets close to what my actual numbers will be........not really hoping for much just for it to run good, it will be tuned by Modacar in livermore CA on 91 octane, with my catalytic converter on, i do have a test pipe but i dont plan to run illegal maybe if i go to a drag strip. I did order a Skunk2 66mm TB but canceled since it was going to take like 3 months to get it (backordered) + i hear it doesnt really do much for what i got....right?
So good luck guess the HP and torque!
mods for dyno: Skunk2 Megapower Racing Exhaust AEM V2 Cold air intake Skunk2 S1 cams Skunk2 cam gears Skunk2 Pro intake manifold Hondata IM gasket Greddy 4-2-1 header Hondata P28 ECU Hondata S300
Edited by 209_dup2 (04/04/08 06:07 PM)
|
Top
|
|
|
|
#2493895 - 03/31/08 08:28 PM
Re: Guess my Dyno #'s
[Re: 209_dup2]
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
ok ill start im guessing 152Hp/ 98 torque!
|
Top
|
|
|
|
#2494301 - 03/31/08 10:18 PM
Re: Guess my Dyno #'s
[Re: strsi]
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
i belive its a in ground dynojet chassis dynamometer
|
Top
|
|
|
|
#2509688 - 04/04/08 06:05 PM
Re: Guess my Dyno #'s
[Re: BGPMPN]
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
Well heres the update 152hp / 108 torque, i was making more but the curve on the graph was dipping low on some parts but the 152 ran better, they advanced my intake 3 and advanced exhaust 1...what ever its 1 more hp than i expected so its all good ha ha ha, i think im going to need a new clutch soon...any ideas
MY DYNO RUN
|
Top
|
|
|
|
#2516496 - 04/07/08 03:57 PM
Re: Guess my Dyno #'s
[Re: strsi]
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
well its 1000X better than not being tuned, if u see the dyno graph u can see i was losing power right arround 5500rpm, now its faster sounds different, but my idle is a bit weird when my engine is cold, because they ajusted my cams now i have my rpms moving allover untill it warms up....well its not no 181.5 whp but it works for me ha ha ha
|
Top
|
|
|
|
#2518714 - 04/08/08 09:33 AM
Re: Guess my Dyno #'s
[Re: strsi]
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
i might go back and tune it again with more parts this time they will focus more on power not on air/fuel, since half the time thats what they ajusted so it ran good
|
Top
|
|
|
|
#2522227 - 04/09/08 08:39 AM
Re: Guess my Dyno #'s
[Re: strsi]
|
Slammed_am
Jr Member
Registered: 03/03/05
Posts: 477
Loc: Old Forge, PA
|
Sounds like a similar setup to what I'm running. I just picked up my cams and cam gears (S2S1) about a week or so ago, and I'm just waiting to get them installed then tuned. Did you have a dyno run before you installed any of your parts? I'd be cool to see how much you actually gained over stock.
Anywa best of luck with it and I'll definately be following your build
|
Top
|
|
|
|
#2527015 - 04/10/08 12:46 PM
Re: Guess my Dyno #'s
[Re: Slammed_am]
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
no i never ran the dyno stock, oh well i just bought parts instead...but the guy said most stock si run about 120-135 on their dyno stock....i was looking forward to getting some 1/4 mile times from Sacramento Raceway but i got their to late and they were not accepting more entries so ill have to go again...when i dont have school, but i seen an si running 16 something had to be wrong with him or the car
|
Top
|
|
|
|
#2545393 - 04/15/08 11:21 PM
Re: Guess my Dyno #'s
[Re: BGPMPN]
|
Slammed_am
Jr Member
Registered: 03/03/05
Posts: 477
Loc: Old Forge, PA
|
I do remember reading somewhere that 99-00 Si's typically run 15's stock in the 1/4 mile....maybe 15.7 or 15.6? I forget exactly.
|
Top
|
|
|
|
#2603595 - 05/02/08 04:12 PM
Re: Guess my Dyno #'s
[Re: strsi]
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
Well i finally made it out to Sac Raceway, and it was fun but my numbers were not that great, but then again everyone at the track was saying it was to hot, and it was making everyone run slower but i don't know about that. It was my first time out there so i guess i need practice but my best # were 15.5@89mph.... Heres a short clip of a few of my races
|
Top
|
|
|
|
#2804334 - 07/09/08 01:22 AM
Re: Guess my Dyno #'s
[Re: PhoenixB16]
|
V-TEC PWR
Newbie
Registered: 07/06/08
Posts: 15
|
Where is the video? I don't like the link, but nice results though!
|
Top
|
|
|
|
#4784205 - 05/31/10 03:21 AM
Re: Guess my Dyno #'s
[Re: Euphoricuck]
|
PsychoEBPSiR
Post Master Sr
Registered: 10/06/00
Posts: 5166
Loc: Vancity,Canada
|
just for comparison...i ran 15.1's all day in my Si with an AEM CAI...thats it. touched some 15.0's too
i went 14.71 @ 93mph with same mods
_________________________
2013 mazda 3 skyactiv 6spd /90 240sx coupe sr20det+2871@14psi=315whp/ 09 EVO X w/big tires PS3 gamertag :AaRonBurgundy Xbox: zEdwardRooney
|
Top
|
|
|
|
#6199156 - 03/10/12 05:17 PM
Re: Guess my Dyno #'s
[Re: PsychoEBPSiR]
|
209_dup2
Poster
Registered: 10/04/05
Posts: 340
Loc: Tracy, CA
|
Well here is an update, got my car tuned again with a new clutch and test pipe, made 170whp/119tq took it to Sac Raceway an ran 14.9 @ 91mph
|
Top
|
|
|
|
Moderator: Runnin@Redline Jr, Dr. BrokenLimits, Professor Paki
|
|